| Also known as | F5469 |
| Diagram | Fig. 14 — ENGINE UNIT FITTINGS AND FOOTRESTS · ref 1 |
| Subsystem | frame |
| Listed in parts books | 1964–1965, 1967–1968, 1970 |
Stud (3-5/16 in. O.A.)
A 3-5/16 in. overall length stud from the Engine Unit Fittings and Footrests section, also known by its earlier number F5469.
This is a stud, 3-5/16 in. overall length, listed under Engine Unit Fittings and Footrests in the parts book. The legacy number F5469 is the same physical part as 82-5469, just from the earlier letter-prefix numbering system.
Read more
Studs like this hold engine hardware to the frame or crankcase, threaded at both ends so a nut can draw the two pieces together. Given the figure it's grouped under, this one is used where the engine attaches into the frame fittings, but our own catalog record doesn't spell out the exact mounting point beyond that heading.
It shows up across catalog entries running 1964 to 1970. If you're matching an existing stud on the bench, check the overall length against what you've pulled off the machine before ordering, since studs of similar profile get used in more than one spot.
Sorry if we got something wrong here. If you think this information isn't correct, .