Pièces pour Triumph, BSA & Norton·Expédition mondiale·Appelez l'atelier : (657) 231-9003
Le Hangar 23
Shop/Category/Fig. 34 — SPEEDOMETER AND TACHOMETER/GEAR,DRIVEN-TACH GRBX
GEAR,DRIVEN-TACH GRBX
View clickable diagram
Details
DiagramFig. 34 — SPEEDOMETER AND TACHOMETER · ref 17
Subsystemelectrical
Listed in parts books1974, 1976–1980

GEAR,DRIVEN-TACH GRBX

Driven gear for the tachometer drive inside the gearbox, part number 71-2653.

PN · 71-2653
Supersedes 70-5578 — earlier factory number for this part.

This is the driven gear for the tachometer drive, part number 71-2653, sitting inside the gearbox where the tach cable picks up its signal to spin the tach head. It's the gear that gets turned by the gearbox internals and in turn drives the tachometer cable up to the instrument. This number supersedes the earlier 70-5578, so if your parts book lists that number for the same location, this is the current part to order.

Read more

The catalog shows this part appearing across a run of gearbox listings, all under the SPEEDOMETER AND TACHOMETER figure, which tells you it lives at the cable-drive end of the gearbox rather than up at the instrument itself.

If you're chasing an erratic or dead tach needle and the cable and head both check out, this driven gear and its mating parts in the gearbox are worth a look. Confirm which gearbox casing and drive setup you've got before ordering, since the catalog record doesn't spell out every variant it fits.

$31.95
Pin your bike to check this part fits.

Sorry if we got something wrong here. If you think this information isn't correct, .

Related parts
Driving gear
PN 70-5157 · Goes with this
BackorderView
TACH DRIVE BOX 1969-ON,650/750 TRI
PN 71-7011 · Goes with this
BackorderView
Tachometer cable (28 in. long)
PN 60-0578 · Goes with this
BackorderView
BUSH,TACHO DRIVE GEARBOX
PN 70-5156 · Goes with this
BackorderView
Flanged bush
PN 70-5155 · Goes with this
BackorderView
End plug - driving spindle
PN 71-2480 · Goes with this
BackorderView
Any questions about this part?

Ed is at the counter. Tell him what you're working on or what doesn't fit, and he'll take it from there with this part already on the bench.