| Also known as | 70-7512A, E7512 |
| Diagram | Fig. 19 — EXHAUST PIPES AND MUFFLERS, TR7RV, T140V · ref 9 |
| Subsystem | exhaust |
| Listed in parts books | 1969–1974, 1976–1980, 1983, 1985 |
Clip
Clamp for the 1-3/8 inch balance pipe connection on Triumph twin exhaust systems.
This is the clamp that holds the balance pipe (crossover pipe) in place where it meets the header pipes on twin-cylinder Triumphs. The catalog lists it simply as a clip, and it shows up across a long run of exhaust system figures spanning both TR6R/T120R and later T140V/TR7RV listings, so it's a small but recurring item in the exhaust hardware lineup. Sized for the 1-3/8 inch balance pipe, this clamp keeps that connection tight and cuts down on exhaust leaks at the joint.
Read more
You'll find it cataloged under a few different forms - 70-7512, 70-7512A, and the older E7512 designation - all pointing to the same physical part. It's a wear item worth keeping on hand since exhaust clamps take a lot of heat cycling over the years and tend to lose their grip eventually.
Given how often this one turns up across different exhaust figures, it's a safe bet you'll need it any time you're pulling apart or reinstalling a balance pipe setup. Give the shop a call if you're not sure which clamp your particular exhaust configuration takes.
Sorry if we got something wrong here. If you think this information isn't correct, .