| Diagram | Fig. 6 — TIMING COVER, CONTACT BREAKER AND COILS · ref 3 |
| Subsystem | engine bottom |
| Listed in parts books | 1960–1962, 1964–1971 |
Hammer-drive screw one
A hammer-drive screw used in timing cover, gearbox inner cover, and crankcase assemblies, later carried under part number 60-4255.
D208-5 is a hammer-drive screw, a small hardware fastener that shows up in a number of engine and gearbox assemblies across the catalog. The parts-book listings put it in the timing cover and contact breaker area, the gearbox inner cover and shaft assemblies, and the crankcase, so it's a fixing you'll run into on more than one part of the motor rather than one dedicated job.
Read more
This part number has appeared in catalog rows spanning 1960 through 1971, and it's been carried forward under a later factory number, 60-4255, if you're cross-checking against a newer parts book. If you're chasing down a hammer-drive screw for one of these areas, have the assembly in front of you so we can confirm which fixing point you're after.
Give us a call or bring the part in if you want us to match it up against what's on your bike before you order.
Sorry if we got something wrong here. If you think this information isn't correct, .