| Listed in parts books | Not catalogued by year yet |
8M BELT 30MM X 816 102T
An 8M HTD toothed drive belt, 30mm wide, 816mm length, 102 teeth, for belt-drive conversions on Triumph twins.
This is an 8M-profile toothed drive belt, 30mm wide, with a 816mm belt length and 102 teeth. It's built to the HTD (High Torque Drive) standard, the type of belt used on final-drive belt conversions for Triumph twins that have been set up to run belt drive instead of chain.
Read more
The part number BELT TRI HTD 3 and the alternate form 816-8M-30 102T both point to the same physical belt. If you're ordering a replacement for an existing belt-drive setup, the numbers on your old belt or in your kit's paperwork should match up with 816-8M-30 102T to confirm you're getting the right one.
We don't have more history on this one beyond the spec itself, so if you're not sure your bike's belt-drive conversion uses this exact length and tooth count, give us a call before ordering.
Sorry if we got something wrong here. If you think this information isn't correct, .