Pièces pour Triumph, BSA & Norton·Expédition mondiale·Appelez l'atelier : (657) 231-9003
Le Hangar 23
Shop/Category/Fig. 8 — CARBURETOR TR7RV/Needle (622/124)
Needle (622/124)
View clickable diagram
Details
DiagramFig. 8 — CARBURETOR TR7RV · ref 8
Subsystemfuel
Listed in parts books1969–1970, 1976–1978, 1980, 1985

Needle (622/124)

Amal Concentric carburetor jet needle, catalog number 99-1036, needle code 622/124.

PN · 99-1036
Superseded by 622/124.

This is the jet needle for an Amal Concentric carburetor, catalog number 99-1036, listed under the needle code 622/124. The needle rides in the carb's needle jet and works with the throttle slide to meter fuel across the mid-range of the throttle opening. As the slide rises and falls the taper on this needle changes how much fuel gets past the jet, so it's one of the parts that decides how the bike pulls off idle and through the midrange.

Read more

Our catalog shows this needle appearing across a range of Amal Concentric carburetor listings, including fitments noted for the T90, T100S, T100C, T100T, T100R, T140V, and TR7RV machines, spanning entries from 1969 into the mid-1980s. Because Amal used different needle profiles for different carb bodies and jet combinations, the 622/124 code is the detail to match against what's stamped or listed for your own carburetor rather than going by model name alone.

If you're rebuilding a Concentric and pulling the old needle to compare, check the number against this one before ordering. Needles look similar side by side but the taper differences matter for how the carb runs, so get the code right rather than eyeballing it.

BackorderAdd it to your cart — we'll source it and confirm the price before you pay.
Pin your bike to check this part fits.

Sorry if we got something wrong here. If you think this information isn't correct, .

Related parts
622/122 Needle jet (.106) 1 Each carburettor
PN 99-1035 · Goes with this
BackorderView
Needle clip (622/067)
PN 99-0510 · Goes with this
BackorderView
Jet holder (622/128)
PN 99-1034 · Goes with this
BackorderView
Any questions about this part?

Ed is at the counter. Tell him what you're working on or what doesn't fit, and he'll take it from there with this part already on the bench.