Pièces pour Triumph, BSA & Norton·Expédition mondiale·Appelez l'atelier : (657) 231-9003
Le Hangar 23
Shop/Category/Fig. 5 — CYLINDER BLOCK AND HEAD TR7RV/Inlet rocker box
Inlet rocker box
View clickable diagram
Details
DiagramFig. 5 — CYLINDER BLOCK AND HEAD TR7RV · ref 41
Subsystemengine top
Listed in parts books1974, 1976–1980, 1985

Inlet rocker box

Inlet-side rocker box for the unit 750 twin cylinder head, housing the inlet rocker gear on OIF-era engines.

PN · 71-3668

71-3668 is the inlet rocker box for the unit-construction 750 twins, the housing that sits on top of the cylinder head over the inlet valve gear and caps off that side of the rocker assembly. It shows up in the parts books under the MANIFOLD AND TAPPETS and CYLINDER BLOCK AND HEAD listings for the T140V and TR7RV, so it's tied to the later OIF-era twins rather than the earlier unit engines.

Read more

The rocker box carries the rocker spindle and covers the valve gear on the inlet side, keeping oil in and dirt out while the rockers do their job actuating the inlet valve. Because there's a separate box for inlet and exhaust, make sure you're ordering the correct side when you order.

Our catalog data on this one comes from three listings spanning the mid-to-late '70s production of these engines. If you're not sure whether your engine takes this exact casting, bring in your old box or the part number off it and we'll match it up before you order.

$52.49
Pin your bike to check this part fits.

Sorry if we got something wrong here. If you think this information isn't correct, .

Related parts
Rocker box gasket
PN 71-2599 · Usually replaced with this
BackorderView
SPINDLE,R/BOX-T140 73-89
PN 71-3549 · Goes with this
BackorderView
STUD-ROCKER BOX 1/4 x 20/28
PN 14-1401 · Goes with this
BackorderView
Bolt - rocker box
PN 21-2206 · Goes with this
BackorderView
O-RING ROCKER SHAFT SEALING TRI 650/750 - .500 x .070
PN 60-3548 · Usually replaced with this
BackorderView
Dowel, rocker box to head
PN 71-2361 · Goes with this
BackorderView
Any questions about this part?

Ed is at the counter. Tell him what you're working on or what doesn't fit, and he'll take it from there with this part already on the bench.