Pièces pour Triumph, BSA & Norton·Expédition mondiale·Appelez l'atelier : (657) 231-9003
Le Hangar 23
Shop/Category/Fig. 3 — OIL PUMP AND RELEASE VALVE AND MANIFOLD/Pressure release valve indicator — pre-unit Triumph
Pressure release valve indicator — pre-unit Triumph
View clickable diagram
Details
Also known asE2795, SRM70-2795
DiagramFig. 3 — OIL PUMP AND RELEASE VALVE AND MANIFOLD · ref 13
Subsystemengine bottom
Listed in parts books1960–1962

Pressure release valve indicator — pre-unit Triumph

Pressure release valve indicator for the oil pump and release valve assembly on pre-unit Triumph engines, part 70-2795.

PN · 70-2795
Supersedes 70-4191 — earlier factory number for this part.

This is the pressure release valve indicator, part number 70-2795, listed in the oil pump and release valve and manifold section for pre-unit Triumph engines. It's the part tied to the pressure relief valve in the oil pump circuit, and our catalog record places it in that assembly.

Read more

The older factory number for this same part was 70-4191, so if your parts book or a used engine turns up that number stamped or listed instead, you're looking at the same component. It also shows up under E2795 and SRM70-2795 in some references.

Our catalog entries for this one run from 1960 to 1962, but that reflects the years it shows up in our records, not a guarantee of exact model-year fitment. Check it against your engine before ordering.

$148.95
Pin your bike to check this part fits.

Sorry if we got something wrong here. If you think this information isn't correct, .

Related parts
Fibre washer, oil pressure release valve at case
PN 70-1670 · Usually replaced with this
BackorderView
Joint washer
PN 70-3334 · Usually replaced with this
BackorderView
OIL SEAL FOR TELL-TALE
PN 70-2793 · Usually replaced with this
BackorderView
PRESSURE RELEASE BODY
PN 70-2794 · Goes with this
BackorderView
Fibre washer
PN GS254 · Usually replaced with this
BackorderView
OIL INDICATOR SPRING
PN 70-2788 · Goes with this
BackorderView
Any questions about this part?

Ed is at the counter. Tell him what you're working on or what doesn't fit, and he'll take it from there with this part already on the bench.