Pièces pour Triumph, BSA & Norton·Expédition mondiale·Appelez l'atelier : (657) 231-9003
Le Hangar 23
Shop/Category/Fig. 4 — GEAR CLUSTERS AND TIMING COVERS/MAINSHAFT COMPLETE WITH BUSH
MAINSHAFT COMPLETE WITH BUSH
View clickable diagram
Details
Also known asT4344
DiagramFig. 4 — GEAR CLUSTERS AND TIMING COVERS · ref 1
Subsystemengine bottom
Listed in parts books1971

MAINSHAFT COMPLETE WITH BUSH

Gearbox mainshaft assembly complete with bush, Triumph part 57-4344 (also T4344).

PN · 57-4344

This is the mainshaft assembly listed as complete with bush, part number 57-4344, also found in older parts books under T4344. It shows up in the gear cluster and timing cover section of the parts catalog, which puts it inside the gearbox where the mainshaft carries the gear cluster and passes power through to the output side.

Read more

Because it's listed "complete with bush," this one comes with its bush already fitted rather than as a bare shaft, which is worth noting if you're comparing against other mainshaft listings that are sold bare. Our catalog record ties this to appearances in 1971, but we'd confirm exact gearbox fitment against your casing and cluster before ordering.

If you're rebuilding a gearbox and pulling the old mainshaft, check the wear on the bush and the gear train it locates before assuming this one is a straight swap - gearbox internals from this era can vary enough between casings that it pays to double check.

BackorderAdd it to your cart — we'll source it and confirm the price before you pay.
Pin your bike to check this part fits.

Sorry if we got something wrong here. If you think this information isn't correct, .

Related parts
NUT MAINSHAFT K/S 1/2X20
PN 57-2686 · Goes with this
BackorderView
Clutch rod bush
PN 57-1391 · Goes with this
BackorderView
BUSHING-HIGHGEAR M/S
PN 57-2753 · Goes with this
BackorderView
GEAR M/S 3RD 250
PN 57-2662 · Goes with this
BackorderView
Gearbox sprocket nut
PN 57-1434 · Goes with this
BackorderView
IST GEAR M/S 16T B25
PN 57-2663 · Goes with this
BackorderView
Any questions about this part?

Ed is at the counter. Tell him what you're working on or what doesn't fit, and he'll take it from there with this part already on the bench.