Pièces pour Triumph, BSA & Norton·Expédition mondiale·Appelez l'atelier : (657) 231-9003
Le Hangar 23
Shop/Category/Fig. 7 — GEARBOX SHAFTS, BEARINGS AND INNER COVER/Mainshaft 2nd gear (20T)
Mainshaft 2nd gear (20T)
View clickable diagram
Details
Also known asT1837
DiagramFig. 7 — GEARBOX SHAFTS, BEARINGS AND INNER COVER · ref 13
Subsystemgearbox
Listed in parts books1966–1969

Mainshaft 2nd gear (20T)

Mainshaft 2nd gear (20T) for the gearbox, later superseded by 57-4031.

PN · 57-1837
Superseded by 57-4031.

57-1837 is the mainshaft 2nd gear, a 20-tooth gear that rides on the gearbox mainshaft inside the inner cover assembly. It's one of the gear pairs that make up the ratio set in the box, and it shows up in the parts books under the GEARBOX SHAFTS, BEARINGS AND INNER COVER figure alongside the rest of the shaft and bearing hardware for that end of the gearbox.

Read more

Older parts books may list this one under its original T1837 form, so if you're working from an early manual and find that number, it's the same physical gear as 57-1837. The catalog record for this one runs across appearances from 1966 to 1969.

Triumph later renumbered this gear to 57-4031, so if your parts book or an older gearbox turns up that number instead, it's the same gear under its later factory designation. Worth checking your gearbox internals against both numbers if you're sourcing a replacement, since either one can turn up depending on which parts book or era your box came from.

BackorderAdd it to your cart — we'll source it and confirm the price before you pay.
Pin your bike to check this part fits.

Sorry if we got something wrong here. If you think this information isn't correct, .

Related parts
Mainshaft bearing (Ball journal)
PN 57-1469 · Goes with this
BackorderView
OIL SEAL 500 TRI G BOX UK
PN 57-1478 · Usually replaced with this
BackorderView
MAINSHAFT c/w THIRD AND LOW GEARS
PN 57-2275 · Goes with this
BackorderView
INNER G BOX CVR 500 TRI
PN 57-1448 · Goes with this
BackorderView
Any questions about this part?

Ed is at the counter. Tell him what you're working on or what doesn't fit, and he'll take it from there with this part already on the bench.