Parts for Triumph, BSA & Norton·Worldwide shipping·Call the Shop: (657) 231-9003
Le Hangar 23
Shop/Category/Fig. 18 — TELESCOPIC FRONT FORK, U.S.A. T100C AND T100R/Middle lug and stem
Middle lug and stem
View clickable diagram
Details
Also known asH2280
DiagramFig. 18 — TELESCOPIC FRONT FORK, U.S.A. T100C AND T100R · ref 2
Subsystemforks front
Listed in parts books1968

Middle lug and stem

Middle lug and steering stem for the telescopic front fork, part number 97-2280 (also H2280), used in 1968 fork assemblies.

PN · 97-2280

This is the middle lug and stem for the telescopic front fork, part number 97-2280, also listed under the older H2280 designation. It's the fork component that carries the steering stem through the frame's steering head, sitting between the top yoke and the fork sliders, and it's what the yoke clamps to when you tighten everything up.

Read more

In the catalog this piece shows up in fork figures for the T100C, T100R, TR6R, T120R, and TR6C, all from 1968. It's a structural part of the front end, so fitment matters here — check it against your steering head bearings and the rest of your fork assembly before you order.

If you're replacing this, it's worth handling the fork as a set rather than swapping just the one piece, since the middle lug and stem works together with the top yoke, bearings, and sliders to keep the steering geometry correct.

BackorderAdd it to your cart — we'll source it and confirm the price before you pay.
Pin your bike to check this part fits.

Sorry if we got something wrong here. If you think this information isn't correct, .

Related parts
Fork stem sleeve nut (blind)
PN 97-2263 · Goes with this
BackorderView
BOLT/NUT SET 3/8X26 - STEERING STEM CLAMPING
PN 82-1760 · Goes with this
BackorderView
Lower bearing
PN 97-0443 · Goes with this
BackorderView
Top bearing
PN 97-0441 · Goes with this
BackorderView
SLEEVE NUT,STEERING UNF
PN 97-2108 · Goes with this
BackorderView
TOP LUG-TR6C 65-68 NOS
PN 97-2101 · Goes with this
BackorderView
Any questions about this part?

Ed is at the counter. Tell him what you're working on or what doesn't fit, and he'll take it from there with this part already on the bench.