Parts for Triumph, BSA & Norton·Worldwide shipping·Call the Shop: (657) 231-9003
Le Hangar 23
Shop/Category/Fig. 1 — CRANKSHAFT AND CONNECTING RODS/CRANKSHAFT ASSEMBLY
CRANKSHAFT ASSEMBLY
View clickable diagram
Details
Also known asE8778
DiagramFig. 1 — CRANKSHAFT AND CONNECTING RODS · ref 1
Subsystemengine bottom
Listed in parts books1969–1973

CRANKSHAFT ASSEMBLY

Crankshaft assembly for the engine bottom end, listed in the crankshaft and connecting rods parts-book figure.

PN · 70-8778

70-8778 is the crankshaft assembly listed under the CRANKSHAFT AND CONNECTING RODS figure in the parts books, also shown under the earlier E8778 form. This is the rotating heart of the bottom end - the shaft the connecting rods, flywheel, and timing/drive gears all hang off of, running in the main bearings in the crankcase.

Read more

A crankshaft assembly like this one is usually supplied complete with its associated hardware as shown in the figure, rather than as a bare forging, though our catalog record doesn't spell out every piece included in this particular listing.

Our catalog record ties this part number to appearances between 1969 and 1973, but doesn't pin it to one specific model. Given that it's a major bottom-end component, get the numbers off your existing crank and check them against your parts book before ordering - crankshafts are not something you want to guess on.

BackorderAdd it to your cart — we'll source it and confirm the price before you pay.
Pin your bike to check this part fits.

Sorry if we got something wrong here. If you think this information isn't correct, .

Related parts
Roller bearing, steel cage
PN 70-8780 · Goes with this
BackorderView
TRIDENT CON ROD
PN 70-9740 · Goes with this
BackorderView
ROD INSERTS T150,STD LFH
PN 70-5998 · Goes with this
BackorderView
Self locking nut
PN 60-3761 · Goes with this
BackorderView
BOLT,CON ROD 3CYL
PN 70-9727 · Goes with this
BackorderView
LOCK NUT CONROD 5/16 UNF
PN 21-2016 · Goes with this
BackorderView
Any questions about this part?

Ed is at the counter. Tell him what you're working on or what doesn't fit, and he'll take it from there with this part already on the bench.