| Diagram | Fig. 32 — CONTROL CABLES · ref 10 |
| Subsystem | controls |
| Listed in parts books | 1973–1974, 1976–1977, 1983 |
Cable clip
A Triumph cable clip (60-0777) used to secure control cables or wiring along the frame or fenders, later superseded by 82-9918.
This is a cable clip, Triumph part number 60-0777, used to secure control cables and wiring where they run along the frame or fenders. It shows up across several parts-book figures - control cables, fenders and stays, and the electrical equipment sections covering ignition coils, horns, and the rectifier/zener diode - so it's one of those small parts Triumph used in more than one spot on the bike to keep cables from flopping around or rubbing on the paint.
Read more
The catalog appearances run from 1973 into 1983, which covers a good stretch of production, but the entry itself doesn't tie this clip to one specific model or cable run. If you're chasing down which exact cable or harness section it holds on your bike, it's worth confirming against the fender or wiring diagram in your parts book before ordering.
This part was superseded by 82-9918, so if your parts book lists the newer number, that's the same physical clip under Triumph's later part numbering.
Sorry if we got something wrong here. If you think this information isn't correct, .