| Also known as | D104 |
| Diagram | Fig. 22 — CONTROL CABLES · ref 25 |
| Subsystem | controls |
| Listed in parts books | 1960–1970 |
Adjuster assembly
Cable adjuster assembly used at the control end of Triumph cable runs, PN 60-0104.
This is the adjuster assembly used on control cables, the fitting that lets you take slack in and out of a cable run at the lever or twistgrip end. It shows up across the control cable figures in our books, including the versions covering American-style handlebars and the T120R twistgrip setup, so it's a control-side part rather than anything at the engine or gearbox end.
Read more
The older factory number for this same piece was 15-9577, later carried forward as 60-0104 (also seen written as D104 in some listings). If your parts book or an old box of spares shows either of those numbers, it's the same physical adjuster.
We don't have more specific detail on which handlebar or cable setup calls for this exact adjuster beyond what's noted above, so if you're matching one on your bike, bring the old part or check your parts book figure before ordering.
Sorry if we got something wrong here. If you think this information isn't correct, .