Parts for Triumph, BSA & Norton·Worldwide shipping·Call the Shop: (657) 231-9003
Le Hangar 23
Shop/Category/Fig. 10 — GEARBOX SHAFTS AND GEARS/OIL SEAL HIGH GEAR T150 - 4 SPEED
OIL SEAL HIGH GEAR T150 - 4 SPEED
View clickable diagram
Details
Also known asT3634
DiagramFig. 10 — GEARBOX SHAFTS AND GEARS · ref 12
Subsystemgearbox
Listed in parts books1969–1972

OIL SEAL HIGH GEAR T150 - 4 SPEED

High gear oil seal for the T150 triple 4-speed gearbox, keeps gearbox oil from leaking out along the high gear shaft.

PN · 57-3634

This is the oil seal for the high gear in the 4-speed gearbox used on the T150 triple. It's a small but important piece that keeps gearbox oil where it belongs instead of working its way out along the high gear shaft. On the old parts books this one shows up under the T3634 designation before the modern 57-3634 numbering took over, so if you're working from an older book and see that number, it's the same seal.

Read more

These seals are cheap insurance against a gearbox that slowly weeps oil out the side case, and since it's a wear item that hardens and shrinks with age over the decades, it's worth checking if yours has never been swapped. Sold individually, so if you're doing a full gearbox rebuild check what else needs replacing at the same time.

Call the shop if you're not sure which seal your particular gearbox needs — there were other seals used elsewhere in the same box and it's easy to grab the wrong one.

$7.49
Pin your bike to check this part fits.

Sorry if we got something wrong here. If you think this information isn't correct, .

Related parts
Gasket, high gear oil seal housing
PN 57-2165 · Usually replaced with this
BackorderView
OIL SEAL HOUSING T150
PN 57-2153 · Goes with this
BackorderView
GASKET SEAL HOUSING (HIGH GEAR)
PN 71-1451 · Usually replaced with this
BackorderView
HI GEAR NUT T150
PN 57-4051 · Goes with this
BackorderView
BEARING - 4 SPEED GEARBOX HIGH GEAR (Replaces 04-0098, 49-00053, 57-0048, 57-0448,68-0023)
PN 60-3556 · Goes with this
BackorderView
Any questions about this part?

Ed is at the counter. Tell him what you're working on or what doesn't fit, and he'll take it from there with this part already on the bench.