| Also known as | 82-0045, F45, F9054 |
| Diagram | Fig. 18 — MOTOR UNIT FITTINGS AND FOOTRESTS · ref 14 |
| Subsystem | frame |
| Listed in parts books | 1968, 1970–1971, 1973–1974, 1976–1980, 1983, 1985 |
PEG RUBBER SQUARE 3/4 HOLE- 4 1/4 IN LONG
Square footrest peg rubber with a 3/4 hole, 4 1/4 inches long, for Triumph footrest pegs.
This is the footrest rubber, the square peg with a 3/4 hole running through it and a length of 4 1/4 inches. It's the rubber sleeve that slides over the footrest peg so your boot has something to grip besides bare steel. Over time these dry out, split, or just spin loose on the peg, and once that happens the peg itself starts wearing.
Read more
Catalog listings for this one show up under a handful of figure titles covering footrests, engine mountings, and frame fittings, so it's used in more than one spot depending on the bike - front or rear peg, the rubber itself doesn't care which. It's also carried under the older alias numbers 82-0045, F45, and F9054, so if your parts book or an old invoice shows one of those, it's the same part.
Appearance across our catalog runs from 1968 into 1985, which tells you this is a long-lived, unchanged design rather than something that got revised partway through. Confirm which peg on your bike takes the square-hole rubber versus a different profile before ordering, since footrest rubber shapes aren't universal across every model and year.
Sorry if we got something wrong here. If you think this information isn't correct, .