Triumph・BSA・Norton 用パーツ·世界中へ発送·お問い合わせ:(657) 231-9003
Le Hangar 23
Shop/Category/Fig. 5 — CARBURETTOR — AMAL CONCENTRIC — SERIES 1900/Sheath - Throttle cable adjuster T140
Sheath - Throttle cable adjuster T140
View clickable diagram
Details
DiagramFig. 5 — CARBURETTOR — AMAL CONCENTRIC — SERIES 1900 · ref 40
Subsystemcontrols
Listed in parts books1979–1980, 1983, 1985

Sheath - Throttle cable adjuster T140

Rubber/plastic sheath covering the throttle cable adjuster where it meets the Amal Concentric carb on T140 models.

PN · 60-7118
Superseded by 316/083.

This is the sheath, or outer cover, that fits over the throttle cable adjuster on T140 models. It sits down at the carburetor end of the throttle cable, where the cable enters the adjuster, and it keeps road grime and water off the adjuster threads and the exposed cable end.

Read more

It shows up in the catalog under the Amal Concentric carburetor figure as well as the control cables figure, which tells you it's a small piece that bridges the two systems - carb and cable - rather than belonging strictly to one or the other.

Our records show this part was later superseded by 316/083, so if you're chasing this down for a T140 and the counter comes back with that number instead, that's the same piece under its current factory number.

BackorderAdd it to your cart — we'll source it and confirm the price before you pay.
Pin your bike to check this part fits.

Sorry if we got something wrong here. If you think this information isn't correct, .

Related parts
4/035 Throttle cable adjuster
PN 99-7096 · Goes with this
BackorderView
Throttle cable T/Grip to junct block T140 High bar
PN 60-7149 · Goes with this
BackorderView
Throttle cable junct block to carb T140 High bar
PN 60-7084 · Goes with this
BackorderView
Throttle cable cpte. T140 Low bar
PN 60-7145 · Goes with this
BackorderView
Throttle cable
PN 60-7633 · Goes with this
BackorderView
Throttle cable T/Grip to junct block T140 Low bar
PN 60-7150 · Goes with this
BackorderView
Any questions about this part?

Ed is at the counter. Tell him what you're working on or what doesn't fit, and he'll take it from there with this part already on the bench.