| Also known as | D732 |
| Diagram | Fig. 32 — CONTROL CABLES · ref 1 |
| Subsystem | controls |
| Listed in parts books | 1971, 1976–1977 |
CABLE ASSY. U.K. BAR T140
Throttle cable assembly for U.K.-spec low handlebars on the T140, running from twist-grip to a junction block feeding two carburetor cables.
This is a cable assembly built for U.K.-spec handlebars on the T140, listed in the catalog under 60-0732 (also shown under the older D732 designation). It's a throttle cable setup made to run with a single-pull twist-grip and the type of carburetor arrangement that needs one upper cable splitting into two lower cables at a junction block, feeding a pair of carbs.
Read more
The assembly shows up in the control cable section of the parts books and covers the run from the twist grip down to the carburetor linkage. Because it's built around the low-rise U.K. bar geometry, the cable lengths are matched to that bar shape rather than the taller U.S.-style bars.
If your bike originally came with U.K. bars, or you've swapped to them and need the corresponding throttle setup, this is the assembly that's meant to go with that configuration. Cross-check your carb setup and bar type before ordering since cable length and routing are matched to that specific combination.
Sorry if we got something wrong here. If you think this information isn't correct, .