| Also known as | D368 |
| Diagram | Fig. 22 — CONTROL CABLES · ref 4 |
| Subsystem | controls |
| Listed in parts books | 1960–1964 |
Nipple
A cable-end nipple used with control cables, the small fitting that anchors the cable in its lever or slide.
This is a nipple, the small fitting that anchors the end of a control cable so it seats properly in the lever or the carburetor slide. It shows up in the catalog under the control cables figures, which is where you'd expect it - these little pieces are what keep a clutch, throttle, or brake cable from pulling through its abutment.
Read more
The older book number for this one is D368, so if you're working from an early parts list and see that reference, it's the same piece as 60-0368. It's a small, simple part but an important one - if the nipple is worn, cracked, or not properly seated, the cable can slip or fail at the worst time.
Our catalog record ties this to control cable work across the early 1960s, appearing in listings for both standard control cables and the American handlebar cable setup. Beyond that we don't have more detail on this one, so give us a call if you want to confirm it's right for your particular cable before ordering.
Sorry if we got something wrong here. If you think this information isn't correct, .