| Also known as | F11533 |
| Diagram | Fig. 27 — IGNITION COILS, HORN, RECTIFIER AND ZENER DIODE · ref 3 |
| Subsystem | electrical |
| Listed in parts books | 1970, 1974 |
COIL BRACKET 1970 650
Coil mounting bracket for the 650 twin, used with the ignition coils, horn, rectifier and zener diode assembly.
This is the coil bracket that carries the ignition coils on the 650 twin, showing up in the catalog for 1970 and appearing in the ignition coil, horn, rectifier and zener diode figure as well as the T100C ignition capacitor and headlamp figure. The bracket gives the coils a fixed mounting point in the electrical cluster under the tank, keeping them steady against vibration while the rest of the ignition and charging hardware hangs off nearby.
Read more
It also carries the older F11533 part number if you're working from an early parts book, so if you see that number stamped or listed anywhere, it's the same physical bracket. Appearances in the catalog run from 1970 through 1974, so it saw a few seasons of use before whatever changed after that.
This is a straightforward mounting piece rather than anything electrical itself — no wiring, no points, no capacitor built in. Give it a look for cracks or bent tabs before you bolt new coils to it, since a bracket that's been pried on over the years won't hold things as square as it should.
Sorry if we got something wrong here. If you think this information isn't correct, .