| Also known as | E6611 |
| Diagram | Fig. 12 — CHAINCASE AND CHAINS · ref 12 |
| Subsystem | primary |
| Listed in parts books | 1967–1968 |
Stud (3.5 in.O.A.)
A 3.5 in. overall-length stud used in the primary chaincase area, likely for mounting the stator, per 1967-68 catalog listings.
This is a stud, 3.5 inches overall length, listed under part number 70-6611 (also shown as E6611 in older parts books). It shows up in the chaincase and chains section of the parts catalog, which is where the primary drive lives on these bikes.
Read more
Other catalog listings tie this same stud to the stator/alternator mounting, so it's likely one of the studs that hold the stator in place inside the primary chaincase rather than a general fastener. Catalog appearances run from 1967 to 1968.
If you're replacing one of these, check the thread and length against what's already on the engine before ordering, since our record doesn't give us a thread spec to confirm against.
Sorry if we got something wrong here. If you think this information isn't correct, .