| Diagram | Fig. 4 — MANIFOLD AND TAPPETS · ref 4 |
| Subsystem | engine top |
| Listed in parts books | 1974, 1976–1980, 1985 |
Washer \ Manifold to head
A small plain flat washer used at the intake manifold-to-cylinder-head joint on Triumph twins.
Part number 60-4248 is a plain flat washer used where the intake manifold bolts up to the cylinder head on Triumph twin-cylinder engines. It's a small, simple piece of hardware, but it does the job of spreading load under the manifold nuts so the joint seats evenly and stays sealed against air leaks.
Read more
Our catalog shows this washer turning up across a wide range of figures over the years, including manifold and tappet drawings, cylinder head assemblies, and even exhaust and electrical figures where a small flat washer of this size gets called out again for other fastener locations. It's a general-purpose piece that shows up more than once on the same engine.
If you're doing a manifold gasket job or chasing an intake air leak, it's worth having a few of these on hand — they're the kind of part that's easy to lose track of when you're pulling the carbs and manifold off for cleaning or rebuilding.
Sorry if we got something wrong here. If you think this information isn't correct, .