Triumph・BSA・Norton 用パーツ·世界中へ発送·お問い合わせ:(657) 231-9003
Le Hangar 23
Shop/Category/Fig. 8 — GEARBOX SHAFTS, BEARINGS AND INNER COVER/High gear bearing (ball Journal)
High gear bearing (ball Journal)
View clickable diagram
Details
Also known asT665
DiagramFig. 8 — GEARBOX SHAFTS, BEARINGS AND INNER COVER · ref 1
Subsystemgearbox
Listed in parts books1964–1970, 1974

High gear bearing (ball Journal)

Sealed ball journal bearing for the high gear shaft inside the gearbox, parts book number 57-0665 (formerly T665).

PN · 57-0665
Available in 3 versions:
OriginalSealedTaiwan

This is the high gear (mainshaft) ball bearing for the gearbox, listed in the parts books under 57-0665 and, on earlier documentation, T665. It shows up in the GEARBOX SHAFTS, BEARINGS AND INNER COVER figure, which places it right where the high gear rides on its shaft inside the gearbox shell.

Read more

It's a sealed ball journal bearing, and it's one of those parts that quietly does its job until it doesn't — worn out or loose bearings here show up as noise or play in the gearbox before anything more serious happens. The catalog carries this number across a long span of production, so it's a part that stuck around in the system for a good while.

Same physical bearing also turns up under other catalog numbers depending on which parts book or supplier list you're working from. If you've got a different number written down for your gearbox, it's worth cross-checking before you assume it's a different part.

$26.49
Pin your bike to check this part fits.

Sorry if we got something wrong here. If you think this information isn't correct, .

Related parts
CIRCLIP - GEARBOX HIGH GEAR BEARING RETAINING -TRI 500
PN 37-0680 · Goes with this
BackorderView
Mainshaft bearing (Ball journal)
PN 57-1469 · Goes with this
BackorderView
Mainshaft High Gear (22T)
PN 57-1947 · Goes with this
BackorderView
INNER G BOX CVR 500 TRI
PN 57-1448 · Goes with this
BackorderView
MAINSHAFT c/w THIRD AND LOW GEAR
PN 57-2276 · Goes with this
BackorderView
Any questions about this part?

Ed is at the counter. Tell him what you're working on or what doesn't fit, and he'll take it from there with this part already on the bench.