| Also known as | 14-114, 14.0114 |
| Diagram | Fig. 29 — FENDERS · ref 17 |
| Subsystem | bodywork |
| Listed in parts books | 1968–1972, 1974–1980, 1983 |
Bolt, master cylinder/plate fixing rear
A 5/16 UNF x 3/4 inch hex bolt used throughout Triumph assemblies, including a rear master cylinder/plate fixing.
This is a 5/16 inch UNF hex bolt, 3/4 inch long, that Triumph used all over the bike as a general fixing bolt rather than one dedicated to a single job. The catalog description ties this particular listing to a master cylinder/plate fixing at the rear, but the same part number turns up across dozens of figures spanning fenders, exhaust brackets, oil tank mounts, rocker box fixings, footrest hardware, and more.
Read more
Because it's a common-thread hex bolt rather than a one-off shaped fastener, Triumph reused it wherever a 5/16 UNF, 3/4 inch bolt did the job. If you're chasing down a specific bolt on your bike, match it against the figure for that area rather than assuming this listing's "master cylinder" note is the only place it fits.
Worth keeping a few of these on hand in the parts drawer since they show up in so many spots on these machines.
Sorry if we got something wrong here. If you think this information isn't correct, .