| Diagram | Fig. 18 — HANDLEBARS AND CONTROL LEVERS T20 · ref 6 |
| Subsystem | controls |
| Listed in parts books | 1963–1965, 1967–1974 |
| Also fits (as replacement) | 1969–1970, 1976–1978 · for 99-0225 |
Screw (13/16 in. U.H.)
Control lever perch clamp screw (13/16 in. U.H.), the fastener securing clutch and brake lever brackets to the handlebar.
Part number 11/013 is the screw that clamps the control lever perch to the handlebar - the fastener holding your clutch or brake lever bracket in place. It shows up across a long run of handlebar and control lever figures in the parts books, spanning both twin and single applications, which tells you this is a widely used piece of hardware rather than something specific to one model.
Read more
This number replaces the earlier factory part 99-0225, so if your parts book or an old box of hardware turns up that number, it is the same screw. The catalog listing calls it a 13/16 in. U.H. screw, and it appears in figures covering everything from early handlebar and control setups through later petrol tank and controls groupings, which is a good sign it saw use across a lot of different years and configurations.
If you're rebuilding a perch or just lost the original screw off a lever clamp, this is worth having in the small parts drawer. Given how many different figures it turns up in, it's not a bad idea to keep a couple on hand.
Sorry if we got something wrong here. If you think this information isn't correct, .